Input Select Switch; Automatic Input Selection - Compaq TFT8030 User Manual

Input Select Switch

The Video Channel Select control is located at the left-hand side
of the lower front bezel. To the left and right of the Select
control are two indicators that display the video channel that is
selected. The left indicator is for Channel 1 and the right
indicator is for Channel 2.
The TFT8030 has three video detection modes described in the
following sections:
Automatic Input Selection (Monitor Default)
Input Recall
User Input Selection using the On Screen Display

Automatic Input Selection

This section describes the monitor's input detection scheme at
the initial power-up or when the user has selected Auto Detect
using the OSD for both Channels 1 and 2.
If only one active video input is connected, the monitor
automatically enables and displays that input. If multiple video
inputs are connected to the monitor (either active or in the
energy saving sleep mode), the monitor detects and displays the
factory default video summarized below.
Channel 1 is assigned to the first valid video connection in the
following order:
Analog 1
Digital 1
Channel 2 is assigned to the first valid video connection in the
following order:
Analog 2
Digital 2
Super Video
Composite Video
8 TFT8030 User's Guide