Compaq TFT5000 User Manual
  1. Manuals
  2. Brands
  3. Compaq Manuals
  4. Monitor
  5. TFT5000
  6. User manual
Compaq TFT5000 User Manual

Compaq TFT5000 User Manual

Compaq flat panel monitor user's guide tft5000
Hide thumbs
Table of Contents

Advertisement

Quick Links

U
'
G
SER
S
UIDE
C
TFT5000 F
P
M
OMPAQ
LAT
ANEL
ONITOR

Advertisement

Table of Contents
loading

Related Manuals for Compaq TFT5000

Summary of Contents for Compaq TFT5000

  • Page 1 ’ UIDE TFT5000 F OMPAQ ANEL ONITOR...
  • Page 2 Compaq Computer Corporation. 1999 Compaq Computer Corporation. All rights reserved. Printed in Taiwan. Compaq and Deskpro are registered in the U. S. Patent and Trademark Office. Microsoft, MS-DOS, Windows, Windows NT, and other names of Microsoft products referenced herein are trademarks or registered trademarks of Microsoft Corporation.
  • Page 3 English Product Features The Compaq TFT5000 Flat Panel Monitor has an active matrix, thin- film transistor (TFT), liquid crystal display (LCD). The monitor features include: 15-inch (38.1-cm) viewable area display 1024 × 768 resolution, plus full-screen support for lower resolutions...
  • Page 4 The resulting solution enables customers to manage and control ongoing software maintenance costs. The UDM is available on the Compaq Support Software CD for Compaq Desktop, Portable, and Workstation Products and the Compaq World Wide Web site (www.compaq.com).
  • Page 5 Setting Up the Monitor To set up the monitor, ensure that the power is turned off to the monitor, computer system, and other attached devices, then follow these steps: 1. Place the monitor in a convenient, well-ventilated location near your computer. 2.
  • Page 6 Agreement packet. IMPORTANT: Always activate a screen saver program, the program- mable sleep timer, the Compaq Display LiteSaver utility, or turn off the monitor when it is not in use for a prolonged period of time. All LCD monitors that display the same static image on the screen for a prolonged period of time may exhibit screen image retention.
  • Page 7 Adjusting the Monitor Height To raise the monitor to the desired height: Place one hand on the side of the monitor panel, press the adjustment button located on the neck, and lift the monitor panel to the correct height. To lower the monitor to the desired height: Position your hand to support the bottom of the monitor panel, press the adjustment button located on the neck, and lower the monitor panel.
  • Page 8 Installing the Pivot Software To install the Pivot rotation software: 1. Insert the Compaq CD-ROM into the CD drive on your computer. 2. Using Microsoft Windows as your operating system, go to Start Run and type x:\Pivot\Setup.exe (where x is the letter designating the CD-ROM drive) in the Open box and click OK.
  • Page 9 After installing the Pivot rotation software on your computer, a monitor icon will appear on the right side of the Microsoft Windows Taskbar at the bottom of your screen. To rotate the screen contents: 1. Click on the monitor icon appearing in the Windows Taskbar. 2.

  • Page 10: Operating The Monitor

    Operating the Monitor No./Icon Control Menu button Minus button Plus button Power switch Power LED *Sleep Timer enables you to set a time for the monitor to power on and power off at the same time every day. It eliminates the need to turn off the monitor at the end of the day and conserves energy.

  • Page 11: Main Menu

    On-Screen Display Settings The adjustments for screen settings are located in the on-screen display (OSD) and can be viewed in one of six available languages. The following menus show the functions at each level: Menu Level 1 Brightness Contrast Auto Adjustment Advanced Menu Exit Brightness...
  • Page 12 Advanced Menu (Continued) Management Factory Reset Exit How to Adjust Settings To launch the on-screen display Main Menu: 1. Press the Menu button Menu will display on the monitor screen. 2. To select an item from the Main Menu, scroll down by pressing the Minus (-) button reverse or back up, press the Plus (+) button .
  • Page 13 4. Adjust the second-level menu displays using the same procedures as the first level. 5. To save the adjustments and exit from the second-level menu, select Save and Return, then select Exit. To launch the Advanced Main Menu: 1. Select the Advanced Main Menu from the Main Menu or press the Menu button twice and repeat procedures 2 and 3 for the previous paragraphs.
  • Page 14 Special OSD Messages Special OSD messages will appear on the monitor screen when identifying the following monitor conditions: Input Signal Out of Range—Indicates the monitor is unable to access the appropriate input signal. Going to Sleep—Indicates the screen display is entering a sleep mode.
  • Page 15 5. Press the Menu button once to enter the adjustment mode for hours. 6. Press the Minus or Plus buttons to adjust the hour. 7. Press the Menu button again to enter the time for minutes. 8. Press the Minus or Plus buttons to adjust the minutes. 9.
  • Page 16 Clock, Clock Phase, and Clock Phase Fine controls explained in the Optimizing Digital Conversion section below. The Compaq LCD Display Assistant utility is used to adjust the screen quality of your monitor. This utility provides on-screen instructions.
  • Page 17 The video controller signal may occasionally call for a mode that is not preset if: You are not using a Compaq standard graphics adapter. You are not using a preset mode. If this occurs, you may need to readjust the parameters of the monitor screen by using the on-screen display.

  • Page 18: Energy Saver Feature

    Energy Saver Feature The energy saver feature has four different modes of operation: Full power Suspend Sleep Programmable Sleep By selecting settings in the computer's Energy Saver utility, you are able to determine the length of the inactivity period before the monitor goes into sleep or programmable sleep mode.
  • Page 19 Care and Maintenance This section explains how to care for and maintain your Compaq monitor during normal everyday use. Protecting the Monitor To protect your monitor from overheating and other types of damage, follow these suggestions: Use only a power source and connection appropriate for this monitor, as indicated on the marking label/back plate.
  • Page 20 Do not open the monitor cabinet or attempt to service this product yourself. Adjust only those controls that are covered by the operating instructions. If the monitor is not operating properly or has been dropped or damaged, contact your Compaq authorized dealer, reseller, or service provider. Cleaning the Monitor To clean the monitor, follow these steps: 1.

  • Page 21: Agency Regulatory Notices

    Modifications The FCC requires the user to be notified that if any changes or modifications are made to this device, not expressly approved by Compaq Computer Corporation, this may void the user's authority to operate the equipment. Cables Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods to maintain compliance with FCC Rules and Regulations.
  • Page 22 Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada. German Ergonomics Notice Compaq Computers, when tested with the Compaq PE1200 Series monitors, were evaluated and found compliant to the requirements of ZH 1/618 (German Safety Regulations for Display Work Places in the Office Sector).
  • Page 23 NERGY Monitors that are marked with the E requirements of the EPA E Partner, Compaq Computer Corporation has determined that this product meets the E efficiency. Specific details on using the Energy Saving features can be found in the energy saver or power management section of the computer manual.

  • Page 24: Specifications

    Specifications Compaq TFT5000 Flat Panel Monitor Display Type Viewable Image Size Face Treatment Maximum Weight (Unpacked) Maximum Dimensions (Landscape Mode) Height Depth Width Maximum Graphics Resolution Text Mode Pixel Pitch Horizontal Frequency Vertical Frequency Environmental Requirements Temperature (Independent of Altitude)

  • Page 25: Power Cord Set Requirements

    Power cord sets must meet the requirements of the country where you use the monitor. For more information on power cord set requirements, contact your Compaq authorized dealer, reseller or service provider. General Requirements The requirements listed below are applicable to all countries: 1.
  • Page 26 Country-Specific Requirements Power Cord Set Requirements: By Country Country Australia Austria Belgium Canada China Denmark Finland France Germany Italy Japan The Netherlands Norway Singapore Sweden Switzerland United Kingdom United States Notes: 1. The flexible cord must be <HAR> Type HO5VV-F, 3- conductor, 1.0 mm2 conductor size.

Table of Contents