Operation; Controls And Features - Gravely Pro-Turn 100 Operator's Manual

WARNING: AVOID INJURY. Read
and understand entire Safety section
before proceeding.

CONTROLS AND FEATURES

See Figure 3 for Controls and Features
locations.
Safety Interlock System
WARNING: Safety interlock system
failure and improper operation of unit
can result in death or serious injury.
Test this system each time the unit is
operated. If this system does not
function as described, do not operate
until repairs are made.
Perform the following tests to ensure the
safety interlock system is working properly. If
the unit does not perform as stated, contact
your Gravely dealer for repairs.
NOTE: When the parking brake is engaged,
the steering levers are locked in neutral.
Test Steering PTO Parking
Levers
STARTING INTERLOCK
1 Neutral Off
2 Forward, On
Neutral,
Reverse
3 Forward, On or
Neutral, Off
Reverse
OPERATING INTERLOCK (ENGINE ON)
4* Forward, On
Neutral,
Reverse
5* Forward, On or
Neutral, Off
Reverse
* Operator lifts off seat.
Parking Brake Interlock System
With the parking brake engaged, the steering
levers must be locked in neutral.
With the parking brake disengaged, the
engine must not start and the engine must
shut off if the operator leaves the seat.

OPERATION

Engine
Brake
Engaged Starts
Engaged or Does Not
Disengaged Start
Disengaged Does Not
Start
Engaged or Shuts Off
Disengaged
Disengaged Shuts Off
Steering Levers
Direction Lever Position
of Travel
Forward Push both levers
forward from
neutral position.
Reverse Pull both levers
backward from
neutral position.
Right Turn Push left lever
farther forward
than the right
lever.
Left Turn Push right lever
farther forward
than the left lever.
Stop Return both
levers to neutral
position.
NOTE: The steering controls are
mechanically locked in neutral whenever the
parking brake is engaged.
NOTE: Aggressive turning can scuff or
damage lawns. ALWAYS keep both wheels
rotating when making sharp turns. DO NOT
make turns with inside wheel completely
stopped. To obtain minimum turning radius,
slowly reverse inside wheel while moving
outside wheel slowly forward.
Ignition Switch
EN - 15
Operate the ignition switch
with the removable key.
The switch has three
positions: Off (1), On (2)
and Start (3). To start the
engine, turn the key to
Start, then release to On.
To stop the engine, turn
the key to Off.