Table of Contents
Advertisement
REMOVING BAGGER KIT
1. Lift thumb latch and remove hose from inlet adapter
and blower assembly (see Figure 14).
2. Remove belt cover.
3. Disengage belt tensioner.
4. Remove V-belt from double pulley (see Figure 12).
5. Remove blower assembly (see Figure 10).
6. Re-install belt cover.
WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
BEFORE EACH USE
1. Check bagger parts for wear, deterioration or
damage. Replace ONLY with Gravely original
service parts before operating.
2. Make sure counterweights are installed.
3. Ensure all hardware is tight.
IMPORTANT: Check tool-less hardware often. Tighten as
needed.
4. Remove any grass buildup from bagger parts.
5. Ensure hose is fastened securely on upper boot
and blower assembly.
6. Ensure mesh bags are installed and the bagger
cover is closed and securely latched.
BAGGING
Starting
1. Start engine and engage PTO according to unit
owner's manual.
2. Set throttle to full.
3. Choose a slow ground speed.
REMOVAL
7. Install discharge chute.
CAUTION: Deflected material may cause injury.
ALWAYS operate mower with bagger cover
closed and secured, blower assembly fastened
securely, or with chute deflector in operating
position.
CAUTION: Always install counterweights on
front axle before operating unit with bagger
attached. Always remove counterweights from
front axle when bagger is removed from the unit.
8. Remove counterweights (see Figure 4).
9. Remove catcher assembly (see Figure 7).
OPERATION
Shut Off
1. Disengage PTO.
2. Shut off unit according to unit Owner/Operator's
manual.
WARNING: Lower attachment, stop engine, and
remove key to prevent unauthorized use. DO
NOT park on slopes.
12
Advertisement
Table of Contents
