Adjusting The Unit To Track Straight; Adjusting Steering Levers - Gravely Pro-Turn 100 Operator's Manual

4
1
1. Tie Rod Jam Nut
2. Tie Rod
3. Steering Lever
4. Brake Interlock
5. Hydrostatic Transmission
Figure 15
ADJUSTING THE UNIT TO TRACK
STRAIGHT
(Figure 16)
WARNING: Prior to adjusting the
tracking of the unit, shut OFF engine,
engage parking brake, and remove
the ignition key.
Check and adjust tire pressure. Increase
pressure on side unit tracks to. DO NOT
exceed maximum recommended tire
pressure (see Specifications on page 37).
If tire pressure adjustment does not solve
tracking problem, adjust the limiter bolts on
the stop bracket (Figure 16). Front bolts
adjust forward and rear bolts adjust reverse.
Lengthen the limiter bolt (move closer to
lever) on side which is too fast.
3
1
2

ADJUSTING STEERING LEVERS

5
Adjust Lever Height
IMPORTANT: Ensure that both levers are
aligned and do not make contact.
EN - 28
1
2
1. Limiter Bolt
2. Jam Nut
3. Steering Lever
4. Stop Bracket
Figure 16
1. Shut off engine and remove ignition key.
2. Remove pivot bolt and angle adjustment
bolt from steering lever assembly and
remove assembly. (Figure 17)
• Position assembly in the upper and
middle holes for highest steering
lever position.
• Position assembly in the middle
and lower holes for the lowest
steering lever position.
1
2
3
1. Angle Adjustment Bolt
2. Pivot Bolt
3. Lower Hole
Figure 17
3
2
1
4