10
AP6532 Series Access Point: Installation Guide
2.6 External Antenna Model Wall Mount Instructions
Wall mounting requires hanging the AP6532 Access Point along its width or length using the pair of
slots on the bottom of the unit. The AP6532 can be mounted onto any plaster, wood, or cement wall
surface using the provided wall anchors. The following illustration shows a lengthwise mount.
2.6.1 Wall Mount Hardware
• Two wide-shoulder Phillips pan head self-tapping screws
• Two wall anchors
• Safety wire (recommended) and security cable (optional)
NOTE
In the event the original mounting screws are lost, the following screws
can be used: (ANSI Standard) #6-18 X 0.875in. Type A or AB Self-Tapping
Screw, or (ANSI Standard Metric) M3.5 X 0.6 X 20mm Type D Self-
Tapping Screw.