Configuring The Main Office; Procedure 3 - Nortel SRG200 Configuration Manual

LD 117 – Define the zone Access Code handling for the branch office zone.
Command
CHG ZACB <zone> [ALL]|[<AC1|AC2> <AC1|AC2>]
Main Office Configuration for SRG200/400 Release 1.5
• At the branch office (see Procedure 5 on
1 Configure the Route List Index.
2 Configure ESN.
These steps can be done using overlays, as described in this section, or in
Element Manager and NRS Manager. For more information, see IP Peer
Networking Installation and Commissioning (NN43001-313). For
information on configuring the dialing plan at the branch office, see the
SRG200/400 Release 1.5 Configuration Guide.

Procedure 3

Configuring the main office

1 Configure the ZACB property for the branch office zone.
Description
Define the Access Codes used to modify local or long-distance
calls in the branch office to force all branch office calls to be
routed to the MG 1000B PSTN.
The ZACB and ZDP properties are used to configure the digit
manipulation behavior of the branch office zone (see step 2 on
page 59).
The ZACB property specifies which calls undergo digit manipulation.
The attribute can be configured in the following ways:
• CHG ZACB <zone>
In this configuration, dialing AC1 or AC2 does not trigger digit
manipulation. SRG user calls are treated exactly the same as
those for main office users.
• CHG ZACB <zone> ALL
In this configuration, calls dialed with AC1 and calls dialed with
AC2 undergo zone-based digit manipulation. All SRG users'
calls can then be routed to the SRG PSTN.
Dialing Plan configuration
page 69):
Page 57 of 254
Configuration Guide