Bay Networks 6300 Quick Start Manual page 25

Remote Annex Quick Start for UNIX
T
his guide is designed for quick installation and configuration of a
Remote Annex with a UNIX host using either Annex Manager on the
UNIX host or Quick2Config Annex, a Windows-based Annex
management tool. The instructions apply to all Remote Annex models
including the Remote Annex 6300.
The instructions in this guide cover:
• Loading Remote Annex software on a Windows system
• Using an installation script to copy the Remote Annex
software from
CD-ROM onto a UNIX host system (load host)
• Installing the Remote Annex hardware
• Setting the network addresses
• Booting the Remote Annex
• Configuring the Remote Annex using Annex Manager or
Quick2Config Annex and the na utility
The sample commands and output that follow the instructions involve a
Remote Annex on an Ethernet network with the IP address 192.9.200.62.
The host system address is 192.9.200.55. Certain commands may vary
depending on the particular UNIX platform you are using for the host.
See the following documents for additional information:
• Remote Annex Administrator's Guide for UNIX
• Remote Annex 6300 Supplement to the Remote Annex
Administrator's Guide for UNIX
• The appropriate Remote Annex hardware installation guide
and installation notes
166-024-857 Rev. A 1