GE PXRQ400T Owner's Manual & Installation Instructions page 13

Installation Instructions
MAKE TUBING CONNECTIONS (cont.)
Interactive interface
Power supply
Filter element
Failure indicator
indicator
Filter element touch key Power supply touch key
Water purifier
3/8" WHITE TUBE
Connected from inlet three way ball valve to
reverse osmosis assembly
1. Connect one end of the 3/8" white tube to the inlet three
way ball valve.
2. Route the loose end of this tube to the white collet fitting
on the Reverse Osmosis assembly.
4. Insert all the way into the fitting.
5. Pull on the tube to be sure it is held firmly in the fitting.
3/8" RED TUBE
Connected from reverse osmosis faucet to drain
adapter
1. Connect one end of the 3/8" red tube to the reverse
osmosis faucet by sliding the tube into the 3/8" brine
output.
fitting on the sink drain adapter.
3. Cut this tube as needed to route it as straight as
possible, without loops, dips, or kinks.
5. Insert all the way into the fitting.
7. With remaining tube connect the other end of the
T-connector.
fitting on the sink drain adapter.
49-6000289 Rev. 1
indicator
Inlet three-way ball valve
Municipal tap water
3/8"White Tube
Faucet
Concentrated water
Purified water
Water inlet
Drainage
OUTLET DRAIN 1 DRAIN 2
INLET POWER
The illustration is for reference only, the actual product shall prevail
1/4" WHITE TUBE
Connected from reverse osmosis assembly to
faucet
1. Connect one end of the 1/4" white tube to the reverse
osmosis faucet by sliding tube into the 1/4" tube input.
2. Route the loose end of this tube to the white collet fitting
on the Reverse Osmosis assembly.
4. Insert all the way into the fitting.
5. Pull on the tube to be sure it is held firmly in the fitting.
1/4" RED TUBE
Connected from reverse osmosis assembly to
reverse osmosis faucet
1. Connect one end of the 1/4" red tube to the reverse
osmosis faucet by sliding tube into the 1/4" brine tube
input.
2. Route the loose end of this tube to the red collet fitting
on the Reverse Osmosis assembly.
4. Insert all the way into the fitting.
5. Pull on the tube to be sure it is held firmly in the fitting.
1/4" YELLOW TUBE
Connected from reverse osmosis assembly to
T-connector
1. Connect one end of the 1/4" yellow tube to the yellow
collet fitting on the Reverse Osmosis assembly.
connect on the T-connector.
4. Insert all the way into the fitting.
5. Pull on the tube to be sure it is held firmly in the fitting.
1/4"White Tube
1/4"Red Tube
3/8"Red Tube
1/4"Yellow Tube
3/8"Red Tube
Drain Clamp
Concentrated water
13