GE PXRQ400T Owner's Manual & Installation Instructions page 11

Reverse osmosis filtration system
Table of Contents

Advertisement

Installation Instructions
FAUCET
INSTALL THE FAUCET
Select the location of the Reverse Osmosis product
above the sink to make the needed connections.
Options are:
• Drill a new hole in the sink top
• Drill a new hole in the countertop next to the sink
NOTE: Check to ensure the Reverse Osmosis faucet
will mount flat against the mounting surface.
NOTE:
the Reverse Osmosis assembly to the faucet. Check
between the faucet and Reverse Osmosis assembly.
49-6000289 Rev. 1
Faucet
Air Gap Window
Brine Input For 1/4" Tube
Brine Output for 3/8" Tube
Escutcheon
O-ring
Countertop
Size
22 mm Hole
Washer
Spacer
Washer
Star Washer
Mounting Nut
Gasket
Cone Washer
1/4" Compression Nut
1/4" Tube
Connect To Filtered Water
INSTALL THE FAUCET (cont.)
1. If drilling is needed, drill a 1-3/8" diameter hole in
procedure for drilling stone, porcelain or stainless
steel. Special drill bits may be needed. Consult a
threaded stud. Slide this wing nut and the adjacent
metal washer off the tubing ends and set them
aside to reinstall in step 4, below.
NOTE:
base ring remain in place on the faucet stud.
3. Work tubing and the faucet stud down into the
black rubber gasket sits flat against the sink or
countertop.
4. On the underside of the sink or countertop, slide
back over the tubing ends and onto the stud. With
the washer in place between the countertop and
wing nut, tighten the wing nut securely.
11

Advertisement

Table of Contents
loading

Table of Contents