Charging The Battery; Initial Start-Up; Checking The Charge Status Of The Battery; Checking The Bits - Parkside PASD 4 B2 Translation Of The Original Instructions

or order number 80001039
(JLH100501700B1 for UK.
The power adapter is avai-
lable from our online shop
see chapter „Spare parts/
accessories".
• Always comply with the
latest safety instructions, as
well as the regulations and
information relating to envi-
ronmental protection.
• Defects resulting from im-
proper handling are not
covered by the warranty.

Charging the battery

1. Insert the USB plug (10) of
the charging cable into the
power adapter (9).
2. Connect the charging cable
connector (11) with the
charging socket (7) on the
device.
3. Plug the power adapter (9)
into a socket.
4. The battery indicator (8)
lights up:
red =
0 - 50 % charged
yellow = 51 - 99 % charged
green =
,
100 % charged
5. Once charging is complete,
disconnect the power adapt-
er (9) from the mains supply.
6. Remove the charging cable
connector (11) from the
charging socket (7).

Initial start-up

Checking the charge
status of the battery
During operation the battery
charge level indicator (8) lights up.
green: 50 - 100 %
yellow: 49 - 30 %
red:
< 30 %

Checking the bits

• Only the insulated bits from
the scope of delivery are
suitable for working under
voltage 1000 V.
• Before each use, the insu-
lated bits must be inspected
by the user. Check the
insulation for any damage,
among other things.
• If there is any doubt about
the safety of the insulated
GB
39