Task - Timing Threshold - Northern Telecom Meridian SL-1 Install Manual

2 - 22 Assembly and installation
Installation and acceptance procedures
for XT machines/System Option 71. Precede with an X to delete a
loop.
5. LM1: This specifies the loop number for member 1 in the group
(second primary loop). Respond with 0-15 for ST machines/System
Option 21, 0-31 for NT machines/System Options 51, 61, or 0-159
for XT machines/System Option 71. Precede with an X to delete a
loop.
6. LM2: This specifies the loop number for member 2 in the group
(third primary loop). Respond with 0-15 for ST machines/System
Option 21, 0-31 for NT machines/System Options 51, 61, or 0-159
for XT machines/System Option 71. Precede with an X to delete a
loop.
7. LM3: This specifies the loop number for member 3 in the group
(fourth primary loop). Respond with;
0-15 for ST machines/System Option 21,
0-31 for NT machines/System Options 51, 61, or
0-159 for XT machines/System Option 71.
Precede with an X to delete a loop.
8. SPAR: This specifies the loop option. Respond with YES to set the
option or the default NO (only prompted if LM3 is configured).

Task - timing threshold.

To define the RPE timing thresholds data respond to the following
overlay program 52.
1. GRP: This specifies the RPE group number. Respond with 1-31.
2. TASK: This specifies the task selection. Respond with TTHS.
3. LFAL: This specifies the loss of frame alignment, in seconds, at
the local site. Respond with 2-999. Default is 10.
4. FAEL: This specifies the frame alignment error rate, in seconds, at
the local site. Respond with 2-999. Default is 600.
5. PCML: This specifies the PCM error rate, in seconds, at the local
site. Respond with 2-999. Default is 600.
6. LFAR: This specifies the loss of frame alignment, in seconds, at
the remote site. Respond with 2-999. Default is 10.
553-2931-200