Nortel Meridian Meridian 1 Release Note page 4

Documentation Release Note
Revision in: "Installation and configuration", page 81 of 176
Projected Inclusion in NTP
* Nortel Networks, the Nortel Networks logo, the Globe mark, SL-1, Meridian 1, and Succession
are trademarks of Nortel Networks.
Nortel Networks
Table 11
Switch S1 and S2 settings
Function Selection
For single Fiber Remote Multi-IPE
Interface unit
Fiber Remote Multi-IPE Interface at
the MMI terminal or modem end
of the daisy-chain
Fiber Remote Multi-IPE Interface in
the middle of the daisy-chain
Fiber Remote Multi-IPE Interface
system monitor address
Physical location of the Fiber
Remote Multi-IPE Interface
Reserved for future use
Note: Switch position: ON= Down Up and OFF= Up Down for S1 and
S2 switches.
This correction will be included in the next standard release of Meridian 1 and
Succession documentation.
24 September 2003
Number: MER-0903-017
Switch and
Switch Setting
Position
S1 Position 1 ON (at local and
and Position 2 remote sites)
S1 Position 1
Position 2 OFF
S1 Position 1 OFF
Position 2 OFF
S1 Positions Refer to Table 9
3-8
S2 Position 1 ON-Remote site
S2 Positions OFF
3-8
ON
4 of 4