Spraying; Tip And Pressure Selection - Graco Project Series Owner's Manual

Spraying

Use only water-based materials. Do not
use materials which state "FLAMMABLE"
on the packaging. For more information
about your material, request a Safety Data
Sheet (SDS) from distributor or retailer.
Keep spray area well-ventilated. Keep a
good supply of fresh air moving through
the area.
1. Set the Speed Control to lowest
available setting.

Tip and Pressure Selection

See table for recommended spray pressure for your material. Refer to paint (material) can for
manufacturer's recommendations.
Speed Control
Tip hole Size
0.008 in. (0.20 mm)
0.010 in. (0.25 mm)
0.012 in. (0.30 mm)
0.014 in. (0.36 mm)
0.016 in. (0.41 mm)
3A4749D
Interior
Stains/
Interior & Exterior
Exterior Solid
Clears Stains
1 – 5 6 – 10
✓
✓ ✓
✓
✓
✓
2. Pointing at a piece of scrap cardboard,
pull the Trigger to test the spray pattern.
3. If needed, slowly increase the Speed
Control to the setting that produces a
good spray pattern.
NOTE: To minimize overspray, always spray
at the lowest speed setting that gives a good
spray pattern.
4. Adjust the sprayer's distance from the
surface and your hand speed to achieve
the desired surface coverage.
NOTE: For proper sprayer operation use only
a tip from the same tip family that came with
your sprayer.
Sprayer Name
Ultra
Ultimate
TC Pro
Coatings
Primers Enamels
6 – 10 6 – 10
✓
✓ ✓
✓ ✓
Spraying
Tip Family Tip Part No.
FFLP FFLPxxx
FFLP FFLPxxx
TCP TCPxxx
Interior Exterior
Latex Latex
Paints Paints
6 – 10 6 – 10
✓
✓ ✓
Filter
Color
Blue
Blue
Blue
Black
Black
15