Startup - Graco Project Series Owner's Manual

Startup

Always start with a fully charged Battery.
See Battery and charger information
shipped with the sprayer.
Replace and charge Battery only in a
well-ventilated area and away from
flammable or combustible materials,
including paints and solvents.
1. Install the cup onto the sprayer as
follows:
a. Verify Pump Filter is installed and
clean.
b. Align VacuValve (on Cup Lid) with
Prime Knob (on sprayer).
c. Push cup assembly onto the
sprayer, twist to lock.
3A4749D
2. Prime the pump as follows:
a. Verify Prime Knob is pointed down
to PRIME position.
b. Install Battery onto sprayer.
c. Open the VacuValve cap and
gently squeeze the FlexLiner until
no more air bubbles appear in the
VacuValve.
NOTE: Tilt the sprayer such that the
VacuValve is the highest point so that all air
in the FlexLiner can be fully evacuated.
Startup
13