Eaton InduTel IP4 Instruction manual
You can see on the Maintenance->Diagnostics->Config-Show page if the debug mode
is active.
Figure 18 . Example configuration, " /debug" switched on
Now, commands can also be executed within a session.
Figure 19 . Command lines within a "session"
To exit the debug mode, you can restore the factory settings or remove the " /debug"
addition from the configuration of the CPU module. To do this, copy the line "config
change CPU ... " but without the " /debug" addition. Run the commands "!config change
CPU ... " , "!config write" and "!config activate" one after the other and then restart the
device.
20
InduTel IP4 InsTrucTIon manual TMF037.A January 2023 www.eaton.com