Memorizing Other Manufacturers' Signals (Learning Mode) - Pioneer VSX-11 Operating Instructions Manual

Memorizing other manufacturers' signals (Learning mode)

If your equipment does not set properly in the preset mode, set its remote control signals in this mode. Even if your
equipment set properly in the preset mode, remote control signals of additional functions can be set. (those not shown in
pages 24 to 27).
RECEIVER TV
TV power
FQ
ENTER
FQ
VOL VOL
CHANNEL
MULTI CONTROL
DVD LD/SAT
CD
VCR TUNER
TV CONTROL
PERSONAL
SURROUND
PRO LOGIC DSP MODE 5-D THEATER VIRTUAL
1 2 3 4
5.1CH TEST TONE CENTER
5 6 7 8
REAR.L REAR.R
9 0 +10 DISC
TV/VCR
FUNCTION MODE CHECK
1 , 6
MULTI COMMANDER 1 , 6
SYSTEM OFF
OPERATION SET UP
D
Î
MULTI CONTROL COMMANDER
PRE-PROGRAMMED AND LEARNING
¶ The TV POWER, TV FUNC, VOL –
and + buttons can only be used
for learning when TV CONTROL
is selected.
¶ When TV CONTROL has been
selected, memorize the same re-
mote control signal into both TV
power and Power.
1.
1.
Set the learning
mode.
Power
2 2.
2
2.
Select the function
to be learned.
1
1
3.
3.
Select the button
of the function to
be learned using
the remote control
unit.
* Select from the
gray buttons in
the left figure of
the remote con-
trol unit.
4.
4.
Face the remote
control units at
each other. Press
the button of the
operation of the
other manufactur-
ers' device to be
learned. (Press un-
til the multi control
button blinks.)
5.
5.
Repeat steps 2 to 4, and learn other required functions.
6.
6.
Exit the learning
mode.
VARIOUS OPERATIONS
COMMANDER
PRO LOGIC
+
SET UP
1
While pressing the
COMMANDER SET
UP button, press 1.
* Multi control section of the
remote control unit will blink.
MULTI CONTROL
DVD LD/SAT
CD
VCR TV CONTROL
* Only the multi control button
The remote control unit is ready
to memorize the operation in the
7
selected button.
* The multi control button of the
remote control unit stops
blinking and lights.
2~5cm
* When learned, the multi con-
trol button of the remote con-
trol unit starts blinking.
COMMANDER
Return to normal operations.
SET UP
* All multi control buttons will
SP A
SP A
SP A
SP A
selected blinks.
VCR
VCR
go off.
39
<ARB7135>
4