Pioneer VSX-11 Operating Instructions Manual page 37

RECEIVER
TV
FQ
3
3
ENTER
FQ
VOL VOL
CHANNEL
MULTI CONTROL
DVD LD/SAT CD
VCR TUNER
TV CONTROL
PERSONAL
SURROUND
PRO LOGIC DSP MODE 5-D THEATER VIRTUAL
1 2 3 4
4
4
5.1CH TEST TONE CENTER
5 6 7 8
REAR.L REAR.R
9 0 +10 DISC
TV/VCR
FUNCTION MODE CHECK
MULTI COMMANDER
SYSTEM OFF
OPERATION SET UP
D
Î
MULTI CONTROL COMMANDER
PRE-PROGRAMMED AND LEARNING
3.
3.
While observing
the display, find the
m a n u f a c t u r e r
name and code.
When the ∞ button is
pressed, the manu-
facturer names are
displayed in the re-
verse order.
SP A
4. Point the remote
4.
control unit towards
the device to be op-
erated, and input the
three-digit code
number confirmed in
step 3 .
* Refer to the LIST
OF MANUFAC-
TURER CODES
on page 46.
7 When there are several manufacturer codes for one manufac-
turer
Some manufacturers use several remote control signals. In such cases, the de-
vice may not operate even if the manufacturer code displayed at the beginning is
input. Perform the following steps, and look for another manufacturer code.
Look for another code of
the manufacturer.
Example: For TOSHIBA
SP A
SP A
VARIOUS OPERATIONS
Each time the button is pressed,
a different preset manufacturer
FQ
name will be displayed. Display
the name of the manufacturer
whose equipment you are using
FQ
and its code will be displayed au-
tomatically.
SP A
SP A
PRO LOGIC DSP MODE 5-D THEATER VIRTUAL
When a three-digit code number
1 2 3 4
is input, the power ON/OFF sig-
5.1CH TEST TONE CENTER
nal will be output from the remote
5 6 7 8
control unit. If the power of the
REAR.L
9 0
device turns ON or OFF accord-
ing to this signal, it indicates that
the device has been set properly.
If the power does not turn ON/
OFF, input another code or use
the learn function.
Each time these buttons are
pressed, other preset codes of the
manufacturer will be displayed.
SP A
SP A
SP A
SP A
.........
37
<ARB7135>
4