Table of Contents
Advertisement
Seat Retainer Adjustment
(Figure 14)
Damage to the seat isolators may occur if
units are operated for an extended period of
time with the seat retainer threaded washer
adjusted too far from the isolator.
The correct adjustment for the seat retainer
threaded washer is 3 – 6 mm (1/8 – 1/4")
below the bottom of the isolator mount.
Adjust to 3 – 6 mm (1/8 – 1/4")
gap between threaded washer
and seat isolator.
2
1. Threaded Washer
2. Seat Isolator
Figure 14
HOUR / MAINTENANCE METER
Hour Meter-only Models
Hour meter measures engine runtime and
cannot be reset.
Maintenance Models
(Figure 15)
When the key is in the on position, the Timer
mode displays. Press the Mode button to
toggle between different models.
Timer: Measures engine runtime until reset.
To reset the timer, press the Mode button to
select TMR1 mode and then hold Mode
button for 3 seconds.
IMPORTANT: Turn ignition key to the off
position when unit is not in use. Some meters
may count hours when the key is in the on
position, even if the engine is off. This results
in inaccurate maintenance intervals.
Service Alerts: Counts down hours until
service is needed and displays "Now" when
service id due. Service time is measured for:
•
Engine oil and filter changes (CHG OIL)
•
Hydraulic oil and filter changes (CHG H
OIL)
•
Air filter service (SVC AIRFILTER)
The service intervals preset into the hour
meter are:
•
Hydraulic oil and filter: First 75 hours and
every 400 hours thereafter
•
Engine oil and filter: First 25 hours and
every 100 hours thereafter
•
Air filter: Every 100 hours
NOTICE: The preset engine oil services
intervals are normal recommended intervals.
Specific engine manufacturer's
recommendations may vary.
To clear a service message, press the Mode
1
button to select Service Alert mode and then
hold the Mode button for 3 seconds.
12-VOLT AUXILIARY POWER
PORT
Use the auxiliary power port to run
compatible 12-volt accessories. The key must
be in the ON position to use.
To reduce battery drain, only use accessories
when the engine is running. To avoid battery-
and electrical-system damage, DO NOT use
high-draw accessories such as light kits, and
turn accessories off before plugging into port.
To help prevent damage, do not use port to
charge delicate accessories such as cell
phones.
NOTICE: The power port reaches 15 amps at
peak and 5 amps continuous.
If port does not have power, a fuse may be
blown. See Electrical Service on page 33.
Keep the protective cap on the port when not
in use.
NOTICE: Only use compatible accessories.
DO NOT use with a 110-volt voltage inverter.
EN - 22
Mode Button
Figure 15
Advertisement
Table of Contents
