Toshiba MMD-UP0071SPH-UL Installation Manual page 21

(1)
(2)
(3)
4
Push [ ON/OFF]
 Operation starts, and in test mode screen (1) opens.
(While stopped, it is screen (2))
 Test mode is done while the operating mode is set to
"Cool" or "Heat".
 The temperature cannot be set in test mode.
 Check codes are displayed in the normal way.
5
After completing test mode, in the "Field
setting menu" screen, push [ ] and [
to select "Test mode", and then push
[ Set/Fix]
 Screen (3) appears.
 Push [ Set/Fix] to end test mode and do normal
operation.
NOTE
Test mode ends 60 minutes after test mode was started,
and the main screen returns.
39-EN
Wireless remote control
1
Turn on the power of the air conditioner.
When power is turned on for the first time
after installation, it takes approx. 5 minutes
until the remote control becomes available.
In the case of subsequent power-on, it takes
approx. 1 minute until the remote control
becomes available. Execute a test run after
the predetermined time has passed.
2
Push "ON/OFF" button on the remote
control, select [ Cool] or [ Heat] with
"MODE" button, and then select
[ HIGH] with "FAN" button.
3
Cooling test run Heating test run
Set the temperature to 62°F Set the temperature to 86°F
with the temp. setup buttons. with the temp. setup buttons.
4
Cooling test run Heating test run
After confirming a signal After confirming a signal
receiving sound "beep" receiving sound "beep"
immediately set the immediately set the
temperature to 63°F with the temperature to 85°F with the
temp. setup buttons. temp. setup buttons.
5
Cooling test run Heating test run
After confirming a signal After confirming a signal
receiving sound "beep" receiving sound "beep"
immediately set the immediately set the
temperature to 62°F with the temperature to 86°F with the
temp. setup buttons. temp. setup buttons.
]
6
4 5 4 5
Repeat procedures → → → .
Indicators "Operation" (green), "Timer"
(green), and "Ready" (orange) in the
wireless receiver section flash in approx.
10 seconds, and the air conditioner starts
operation. If any of these indicators does not
2 5
flash, repeat procedures to .
7
Upon completion of the test run, push
"ON/OFF" button to stop operation.
<Overview of test run operations using the wireless
remote control>
▼Cooling test run:
ON/OFF → 62°F → 63°F → 62°F → 63°F → 62°F →
63°F → 62°F → (test run) → ON/OFF
▼Heating test run:
ON/OFF → 86°F → 85°F → 86°F → 85°F → 86°F →
85°F → 86°F → (test run) → ON/OFF
– 20 –
EN
40-EN