Honda BF15D Manual page 388

BF15DaBFZOD
2. POWER TILT RELAY
a. REMOVAL
1)
Remove the following:
-
engine cover (P. 5-1 of the base shop manual).
2) Open the wire band and free the wires.
3) Remove the wires from the wire clip on the connector
holder. Pull the connector holder from the starter case B
with the mounting rubbers attached.
4) Disconnect the power tilt relay 2P and 1 P connectors.
5) Disconnect the power tilt relay connectors from the power
tilt switch wire (Tiller handle type) or main wire harness
(Remote control type).
[ l ] WIRE CLIP (2)
[3] WIRE BAND
[41
RELAY WIRE
[ I ] CONNECTORS
16-7