Haier HW80-BP14636N User Manual page 26

10- Inst allat ion
Note: Keep in safe place
Keep t he t ransport at ion bolt s in a safe place for later use. Whenever t he appliance is to
10.4 Moving the appliance
If t he machine is to be moved to a dist ant locat ion, replace t he t ransport at ion bolt s re-
moved before inst allat ion to prevent damage:
1. Remove t he blanking plugs.
2. Remove t he back cover.
3. Insert t he plast ic spacers and t he t ransport at ion bolt s.
4. Tighten t he bolt s wit h a spanner.
5. Replace t he back cover.
10- 6
10.6 Drain w ater connection
Fix t he water drain hose properly to t he piping. The hose has to reach at one point a height
between 80 and 100 cm above t he appliance bottom line! If possible keep always drain
WARNING!
▶
Use only t he supplied hose set for t he connect ion.
▶
Never reuse old hose set s!
▶
Only connect to cold water supply.
▶
Before connect ion, check whet her t he water is clean and clear.
26
10.5 Aligning the appliance
Adjust all feet (Fig. 10- 6) to achieve a complete level
posit ion. This will minimize vibrat ions and t hus noise
during use. It will also reduce wear and tear. We recom-
mend to use a spirit level for adjust ment . Floor should
be as st able and fl at as possible.
1. Loose t he locknut (1) by using a wrench.
2. Adjust t he high by turning t he foot (2).
3. Tighten locknut (1) against t he housing.
GB