Haier HW80-BP14636N User Manual page 23

GB
Program Cause
•
Water level sensor error.
FA
• Temperature sensor error.
F3
• Heat ing error.
F4
•
Motor error.
F7
• Abnormal communicat ion error.
FC0、 FC1
or FC2
• Unbalanced load error.
UnB
9.3 Troubleshooting without display code
Problem
Washing machine fails
to operate.
Washing machine
water.
Machine is draining
Drainage failure.
Strong vibration while
spinning.
Operat ion stops
before complet ing
wash cycle.
Operat ion stops for
a period of t ime.
Cause
•
Programme is not yet st arted.
•
Door is not properly closed.
• Machine has not been switched on.
• Power failure.
• Child lock is act ivated.
•
No water.
• Inlet hose is kinked.
•
• Water pressure is less than 0.03 MPa.
•
Door is not properly closed.
• Water supply failure.
• Height of drain hose is below 80 cm.
• Drain hose end could reach into
water.
• Drain hose is blocked.
•
• Drain hose end is higher than 100 cm
above fl oor level.
• Not all t ransport at ion bolt s have
been removed.
• Appliance has no solid posit ion.
• Machine load is not correct .
• Water or elect ric failure.
•
Appliance displays error code.
• Problem due to load pattern.
• Programme performs soaking cycle.
9-Troubleshoot ing
Solution
•
Contact the After sales service.
• Contact the After sales service.
• Contact the After sales service.
•
Contact the After sales service.
• Contact the After sales service.
• C e h k c a d n b
Reduce the load.
Solution
•
Check programme and start it.
•
Close t he door properly.
• Switch t he machine on.
• Check power supply.
• Deact ivate child lock.
•
Check water t ap.
• Check inlet hose.
•
• Check water pressure.
•
Close t he door properly.
• Ensure t he water supply.
• Make sure t hat drain hose is
properly inst alled.
• Make sure t he drain hose is not
in water.
• Unblock drain hose.
•
• Make sure t hat drain hose is
properly inst alled.
• Remove all transportation bolts.
• Ensure solid ground and a levelled
position.
• Check load weight and balance.
• Check power and water supply.
•
Consider display codes.
• Reduce or adjust load.
• Cancel programme and rest art .
l a n a e c a l n u r d l y a o i d t n e h d u r . m
23