Sony ILCE-3000K Service Manual page 11

2-1-5. IMAGER UNIT SECTION
ns: not supplied
ns
(All mounted parts and IS-1007 complete board are not supplied,
but they are included in Mecha Device (1100) (Service).)
201
202
203
(Note)
Ref. No. Part No. Description
201 4-281-914-01 IM SPACER (869)
202 4-281-915-01 IM GS TAPE
203 1-856-482-11 FILTER BLOCK, OPTICAL (Note)
#191 4-188-735-01 SCREW (M1.7)
ILCE-3000K/3500J_L2
ns
Screw
#191: M1.7 X 3.5
(Black)
4-188-735-01
1.7
3.5
Note
Note : Refer to the following statements when replacing the Optical
#191
filter block.
Method of Removal
(1) Pour resolvent (alcohol or cleaning agent) between the
imager and the IM spacer.
∗ Wait for that the adhesive power of the IM spacer
weakens.
(2) Remove the IM spacer from the imager.
Method of Attachment
(1) Attach the IM GS tape and the Optical filter block by
aligning them with the outer shape of the IM spacer
evenly.
∗ The two-layer side of the Optical filter block is on the
imager side.
The two-layer
side is on the
imager side.
Mount Imager
Side Side
Optical Filter Block
(2) Set the Optical filter block in its attachment jig
(J-6082-737-A), with the attached adhesive face of IM
spacer facing upward.
(3) Press the imager down into the jig as shown below to
attach it to the Optical filter block.
Imager
J-6082-737-A
2-7
Pour resolvent (alcohol or cleaning agent)
between the imager and the IM spacer.
Peel off the
released paper.
Peel off the
released paper.
Peel off the
released paper.
IM Spacer
IM GS Tape
Peel off the released paper.