Table of Contents
Advertisement
4
Changing the Gas Tip
NOTE: Make sure the hole in the gas tip easily slips over the clean-out wire. If
the wire bumps the gas tip, damage to the clean-out wire may occur.
Coleman® Fuel
Unleaded gasoline
Coleman® 3250 Butane/Propane
No
Groove
■ Turn the flame adjuster fully counter-clockwise
wire (Fig. 4).
■ Remove the impingement plate (Fig. 5).
■ Use the combination tool provided with the stove to replace the gas tip
(Fig. 6).
■ See chart above to match the fuel type with the correct gas tip.
■ Reinstall the impingement plate.
Lower the
clean-out wire.
FIG. 4
Stove Set Up
5
■ Unfold stove by lifting legs out of
detents and rotating out until
legs snap into the open position
(Fig. 7). Place the stove on the
reflector disc.
FUEL
Kerosene
NOTE: The reflector disc and windscreen are not illustrated in
the set up instructions. This is so the features of the stove may
be clearly visible and identified. Read about the reflector disc
and windscreen in Sections 1 and 17.
FIG. 3
FIG. 5
English-7
GAS TIP
No Groove
No Groove
Groove
No Groove
Groove
to lower the clean-out
FIG. 6
FIG. 7
Advertisement
Chapters
Table of Contents
