Disconnect the power supply before (dis)connecting any wires, uPASS Target is NOT hot-swappable, so when • making or changing connections, power must be switched OFF. To be sure of safety, do not modify or add anything to the uPASS Target other than mentioned in this installation • guide or indicated by Nedap N.V.
Page 3
Target | quick reference guide Pole mounting set Figure 3: Pole Mounting Set Weather protection hood Figure 4: Weather Protection Hood...
Page 4
Target | quick reference guide Connections All connectors shown in this chapter are seen from the outside of the reader. Figure 5: uPASS Target connectors CONN.1 CONN.2 CONN.3 Function Function Function RS422 TX- Input 1 / UL Relay NO...
Ground ON=RS422, OFF=RS485 DC power supply A DC power supply can be connected to the uPASS Target via CONN. 5. This DC power supply must be able to deliver 12Vdc/1.5A or 24Vdc/0.75A. Power over Ethernet Power over Ethernet operates over Ethernet cables. CONN. 4 is a RJ45 Ethernet connection and can be used for Power over Ethernet.