When The Multipath Driver Is Used - Fujitsu ETERNUS DX Configuration Manual

Chapter 1 Workflow
1.2

When the Multipath Driver is Used

1.2 When the Multipath Driver is Used
The documents and workflow required when a multipath driver is used are as follows.
Workflow
Setting Up the ETERNUS DX
Set the various parameters required to operate the ETERNUS DX.
• Checking the setup and maintenance operations
"Chapter 2 Checking the Server Environment" (page 10)
-
"Chapter 4 Setting Up the ETERNUS DX" (page 13)
-
"ETERNUS Web GUI User's Guide"
-
Setting up the ETERNUS DX
•
- "Configuration Guide -Server Connection- Storage System Settings" that corresponds to the ETER-
NUS DX to be connected
Setting Up the SAS Switches
Set up the SAS switch.
"Chapter 5 Setting Up the SAS Switches" (page 14)
•
Installing the Driver
Install the appropriate driver for the SAS card being used.
• Checking the SAS card driver versions
"Chapter 6 Installing the Driver" (page 16)
-
"Server Support Matrix"
-
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (SAS) for Linux
Copyright 2018 FUJITSU LIMITED
8
P3AM-3472-14ENZ0