Chapter 1
Workflow
1.1
When the Multipath Driver is not Used
Setting Up the SAS Switches
Set up the SAS switch.
"Chapter 5 Setting Up the SAS Switches" (page 14)
•
Installing the Driver
Install the appropriate driver for the SAS card being used.
Checking the SAS card driver versions
•
-
"Chapter 6 Installing the Driver" (page 16)
"Server Support Matrix"
-
Setting Up the Server
Set the parameters required for connection to the ETERNUS DX.
"7.1 For Fujitsu SAS Cards" (page 17)
•
"7.2 For LSI Logic SAS Cards" (page 17)
•
Setting Up the Server to Recognize the Logical Units
Set up the server so that it can recognize the LUNs (logical unit numbers) of the ETERNUS DX.
"Chapter 8 LUN Recognition" (page 18)
•
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (SAS) for Linux
Copyright 2018 FUJITSU LIMITED
7
P3AM-3472-14ENZ0