Table of Contents
Advertisement
2. Tighten the long screw into the holes of the tank bracket
and cover the drainage hole with the big cap, cover the
inlet hole with the small cap.
2.
3. Connect tap water braided tube on the top of water tank for
water supply as shown.
Note: 1. Ensure water tank internal valve is OFF.
2. Suggestion: connect a temporary rubber or plastic
hose on valve, flush water supply pipeline. Ensure
water is clean, no residual sand stone or fouling
inside pipeline.
3.
1.
2.
4. According to different faceplates,there are different
installations of access panel as below.
4.
1) K-20341T-PNE/K-75890T-PNE/K-24149T/K-24151T
Access Panel Installation Methods:
There are four ways to install access panel:
Method one: Press from top
Method two: Remote plate installation: fix four plates
with screws
Method three: Remote installation of mask
Method four: Press from front: fix four plates with screws
1)
K-20341T-PNE/K-75890T-PNE/K-24149T/K-24151T
1402749-T01-A
All manuals and user guides at all-guides.com
:
-8-
Inlet Hole
Drainage Hole
Big Cap
Connecting Pipe
Water Pipe
Method one:
Press from top
Suggested faceplate
Method three:
Remote installation of mask
Suggested faceplate
installation area
R1000mm
Air hose
Tank Bracket
Small Cap
Long Screw
Method two:
Remote plate installation
Pinch
plate
installation area
R1000mm
Air hose
Method four:
Press from front
Pinch plate
Finished
Air hose
wall
Suggested/
80 3
Advertisement
Table of Contents
