Edp (Vesa Embedded Display Port™); Figure 2-2. 40-Pin Edp Mb Header - Intel Thin Mini-ITX System Design Manual

Table of Contents

Thin Mini-ITX Internal Electrical Interfaces

2.2.2

eDP (VESA Embedded Display Port™)

For flat panel resolutions greater than 1920x1200, eDP is defined in this section. eDP

is not a required interface as of this document revision, however shall the board

vendor wish to provide eDP support as a value-add it must be implemented per the

requirements listed below. Please consult with Intel for further implementation

guidance.

An internal 40-pin eDP panel and backlight connector for four-lane, 2.7Gbps and

1.62Gbps eDP flat panel display support is optional. The design must support up to

maximum resolution and color depth allowed by the graphics processor. The design

must be Embedded Display Port

as well as Direct Drive Monitor (DDM, to allow use of large/AIO panels)

The 40-pin eDP connector must be vertical, single-row shrouded colored black, as

shown in the below figure. Connector must support four lanes of eDP traffic, AUX

channel, panel logic power as well as backlight power and control signals, compliant

with the VESA Embedded Display Port™ (eDP) Standard for 40-pin eDP pin

assignment, as defined in the below table.

40-pin eDP connector: 1x40, 1A rating per pin, black (reference part number: ACES

50203-040)

Mating plug reference part number: ACES 88441-40

Thin Mini-ITX Based PC System Design Guide

(eDP) v1.1a compliant and support hot-plug detect

Table of Contents