Table of Contents
Advertisement
Reversing Camera
(B)
STEP THREE: Accessing the Power Source.
You must now determine a route to run your reversing camera's wiring to the power
source (the reverse taillight power wiring). Follow pictures C below for a sample route.
Depending on the type of vehicle, the below pictures may not provide an exact replica of
your vehicle set up. For example, an SUV would require a similar route, but along a
different interior. Slip ties (not included) or some other fastener may be needed to
properly run the power wire to the power source.
If you are using the lower portion (see picture B below) of the license
plate:
i.
Place one shim behind the reversing camera screw holes and
then the other shim on the front portion of the reversing camera
screw holes;
ii.
Insert the screw/bolt through the front shim and continue
through the reversing camera screw holes through the rear
shim and then into the lower portion license plate hole;
iii.
Screw into the body, but do not screw all the way in yet;
iv.
Repeat steps i. – iii. with the second screw into the other lower
portion license plate hole; and
v.
Now tighten both screws/bolts until the reversing camera and
license plate are firmly secured to the vehicle body.
B
C
24
Hide quick links:
Advertisement
Table of Contents
