Nextar I4-BC Instruction Manual page 23

into your vehicle directly adjacent to your license plate, you will need to drill a
hole in to your vehicle adjacent to your license plate with a power drill or
some other means (SEE CAUTION BELOW). Once a hole is found or made,
then take the reversing camera power wire and insert into the hole. From the
inside of the hole, pull the wire all the way through until there is enough slack
to allow proper placement of the reversing camera to the vehicle body with
license plate.
CAUTION: Drilling into the body of your vehicle could cause damage to vital
vehicle components such as electrical wires, spare tires, automobile jacks,
etc. With this in mind, check directly behind where you plan on drilling into
the vehicle body to confirm that no such components are obstructing the
path of the drill bit.
(c) Third, depending on variables such as the height of your license plate from the
ground and the angle view you are looking for, you will either:
(A) use the upper portion (see picture A below) of the license plate and
then:
i.
ii.
iii.
iv.
v.
vi.
Place one shim behind the reversing camera screw holes and
then the other shim on the front portion of the reversing camera
screw holes;
Insert the screw/bolt through the front shim and continue
through the reversing camera screw holes through the rear
shim and then into the upper portion license plate hole;
Screw loosely into the body, being careful not to not screw in all
the way;
Repeat steps i. – iii. with the second screw/bolt into the other
upper portion license plate hole;
Now tighten both screws until the Reversing Camera and
license plate are firmly secured to the vehicle body; and
OPTIONAL: Securely fasten the lower portion screws/bolts to
the lower portion of the license plate.
A
23
Reversing Camera