Installation Procedures - HP MSM720 Installation Manual

CAUTION:
Ensure all port covers are installed when the port is not in use.
There are no user-serviceable parts inside these products. Any servicing, adjustment,
maintenance, or repair must be performed only by service-trained personnel.
These products do not have a power switch; they are powered on when the power cord is
plugged in.

Installation procedures

These steps summarize your controller installation. The rest of this chapter provides details on these
steps.
"Prepare the installation site" (page
will be installing the controller is properly prepared, including having the correct network
cabling ready to connect to the controller and having an appropriate location for the controller.
"Verify the controller passes self test" (page
observe that the LEDs on the controller front panel indicate correct controller operation.
"Mount the controller" (page
an equipment cabinet, on a wall, or on a horizontal surface.
"Connect the controller to a power source" (page
it into the main power source.
"Connect the network cables" (page
network devices to the controller ports.
"Installing or removing optional mini-GBICs" (page
mini-GBICs. Depending on where you install the controller, it may be easier to install the
mini-GBICs first.
Prepare the installation site
Ensure the cabling infrastructure meets the necessary network specifications.
Before installing the controller, plan its location and orientation relative to other devices and
equipment:
◦
In front of the controller, leave at least 7.6 cm (3 inches) of space for the twisted-pair and
fiber-optic cabling
◦
Behind the controller, leave at least 3.8 cm (1 1/2 inches) of space for the power cord.
◦
On each side of the controller, leave at least 7.6 cm (3 inches) for cooling.
Verify the controller passes self test
1. Before mounting the controller in its network location, verify that it passes its self test.
2. Connect the AC/DC adapter's power cord to the power connector on the back of the controller
and then plug the AC/DC power adapter into a nearby properly grounded electrical outlet.
8 Installing the controller
8). Make sure the physical environment into which you
8). Plug the controller into a power source and
10). The controller can be mounted in a 19-inch telco rack, in
12). Once the controller is mounted, plug
13). Using the appropriate network cables, connect the
13). The controller has two slots for installing