Installation; Precautions - HP Aruba 7010 Series Installation Manual

!
Installation of the device should be performed by a trained installation professional.
CAUTION
This chapter describes how to install an Aruba 7010 controller using the many mounting options
available. The 7010 controller ships with an accessory kit that includes the equipment needed to
install the controller in standard, 19-inch telco rack or on a wall.
"Precautions" on page 17

"Selecting a Location" on page 18

"Rack Mounting- Standard" on page 18

"Table or Shelf Installation" on page 20

"Wall Mounting" on page 20

"Installing an SFP" on page 23

Please only use the included or Aruba specified cables, power cords, AC power supplies, and batteries. The
power cord should not be used with other electric equipment than what is specified by Aruba.
!
CAUTION
接続ケーブル、電源コード、AC アダプタ、バッテリーなどの部品は、必ず添付品または指定品をご使用ください。
また、電源ケーブルは弊社が指定する製品以外の電気機器には使用できないためご注意ください。

Precautions

Ensure that the rack is correctly and securely installed to prevent it from falling or becoming

unstable.
Dangerous voltage above 240VAC is always present while the Aruba Power Supply Module is

plugged into an electrical outlet. Remove all rings, jewelry, and other potentially conductive
material before working with this device.
Never insert foreign objects into the chassis, power supply, or any other component, even when

the power supply is turned Off, unplugged, or removed.
Ensure that the main power is fully disconnected from the controller by unplugging all power

cords from their outlets. For safety, verify that the power outlets and plugs are easily reachable by
the operator.
Do not handle electrical cables which are not insulated. This also includes network cables.

Keep water and other fluids away from the controller to minimize electrical hazards.

Comply with electrical grounding standards during all phases of installation and operation of the

product. Do not allow the controller's chassis, network ports, power supply, or mounting brackets
to contact any device, cable, object, or person attached to a different electrical ground. Also, never
connect the device to external storm grounding sources.
Aruba 7010 Series Controller | Installation Guide
Chapter 2

Installation

Installation |
17