Typical Wiring - Beckett GeniSys 7575 Manual

Typical Wiring:

Figure 2 – 7575A
Interrupted ignition, no valve-on or motor-off delay
►
MOTOR
SAFETY AND
OPERATING
L1
LIMITS
L2
Figure 3 – 7575P
Interrupted ignition, valve-on and motor-off delays
►
MOTOR
SAFETY AND
OPERATING
L1
LIMITS
L2
OIL VALVE
NOTES:
1.) Motor-off delay on a 7575P will be disabled if the safety and operating limits, as shown in this figure, interrupt power to the control
terminal L1. Connect thermostat leads to the T-T terminals on the control or jumper the T-T terminals on the control as directed by
the appliance wiring diagram.
2.) If the thermostat short cycles or operates improperly, it may require an isolation relay for proper operation.
120v GeniSys Control Installation and Operation Manual
IGNITER
IGNITER
IGNITER
L2 (IGN)
GeniSys
MOTOR
Control
L2 (MTR)
LIMIT
L1
LIMIT
L2
VALVE
T-T
L2 (VLV)
CAD CELL
IGNITER
L2 (IGN)
GeniSys
MOTOR
Control
L2 (MTR)
L1
LIMIT
L2
VALVE
T-T
L2 (VLV)
JUMPER/
THERMOSTAT
JUMPER/
THERMOSTAT
CAD CELL
7