Table of Contents
Advertisement
UM353TP-1
•
For devices with explosion protection: training, instruction or authorization to work on electrical circuits for
systems that could cause explosions.
•
Training or instruction according to the safety standards in the care and use of suitable safety equipment.
Scope
This manual does not purport to cover all details or variations in equipment, nor to provide for every possible
contingency to be met in connection with installation, operation, or maintenance. Should further information be
desired or should particular problems arise which are not covered sufficiently for the purchaser's purposes, the
matter should be referred to one of the support groups listed in the Product Support section of this manual.
The contents of this manual shall not become part of or modify any prior or existing agreement, commitment or
relationship. The sales contract contains the entire obligation of Siemens. The warranty contained in the contract
between the parties is the sole warranty o Siemens. Any statements continued herein do not create new warranties or
modify the existing warranty.
General Warnings and Cautions
The perfect and safe operation of the equipment is conditional upon proper transport, proper storage, installation and
assembly, as well as, on careful operation and commissioning.
The equipment may be used only for the purposes specified in this User's Manual.
Electrostatic discharge can damage or cause the failure of semiconductor devices such as integrated
circuits and transistors. The symbol at right appears on a circuit board or other electronic assembly to
indicate that special handling precautions are needed.
•
A properly grounded conductive wrist strap must be worn whenever an electronics module or circuit board is
handled or touched. A service kit with a wrist strap and static dissipative mat is available from Siemens
(PN15545-110). Equivalent kits are available from both mail order and local electronic supply companies.
•
Electronic assemblies must be stored in static protective bags when not installed in equipment.
i|config is a trademark of Siemens Energy & Automation, Inc. Other trademarks are the property of their respective owners.
Siemens Energy & Automation, Inc. assumes no liability for errors or omissions in this document or for the application and use of the
information included in this document. The information herein is subject to change without notice.
Procedures in this document have been reviewed for compliance with applicable approval agency requirements and are considered sound
practice. Neither Siemens Energy & Automation, Inc. nor these agencies are responsible for repairs made by the user.
April 2002
WARNING
CAUTION
Contents
!
iii
Advertisement
Table of Contents
