NETGEAR WG511T User Manual page 19

User Manual for the NETGEAR 108 Mbps Wireless PC Card 32-bit CardBus WG511T
Table 2-1. A Road Map for How to Get There From Here ...
If I Want To ... ? What Do I Do?
Connect to the
1. Activate my
Internet over my
wireless link
wireless
and verify my
network.
network
connection.
2. Open an
Internet
browser such
as Internet
Explorer or
Netscape
Navigator.
Introduction
What's Needed?
1. An active Internet connection
like those from cable or DSL
service providers.
2. A wireless network connected
to the cable or DSL Internet
service through a cable/DSL
router as illustrated in
"Connecting to an Access
Point in Infrastructure Mode"
on page 4-2.
3. TCP/IP Internet networking
software installed and
configured on my notebook PC
according to the requirements
of the Internet service provider.
4. A browser like Internet
Explorer or Netscape
Navigator.
How Do I?
To configure your WG511T in
Infrastructure Mode, see
Installation Instructions" on
page 3-4, and locate the section
for your version of Windows.
For assistance with configuring
the TCP/IP Internet software on
a PC, see "Preparing Your
Computers for TCP/IP
Networking" on page C-1
to the PC Networking Tutorial on
the NETGEAR 108 Mbps
Wireless PC Card WG511T
Resource CD (SW-10036-01)
and the Help information
provided in the Windows system
you are using.
.
"Basic
or refer
2-5