Observing Location And Range Guidelines; Two Basic Operating Modes - NETGEAR WG511T User Manual

User Manual for the NETGEAR 108 Mbps Wireless PC Card 32-bit CardBus WG511T
• Some versions of Windows may ask for the original Windows operating system installation
files to complete the installation of the WG511T driver software.

Observing Location and Range Guidelines

Computers can connect over wireless networks indoors at a range which vary significantly based
on the physical location of the computer with the NETGEAR 108 Mbps Wireless PC Card 32-bit
CardBus WG511T . For best results, avoid potential sources of interference, such as:
• Large metal surfaces
• Microwaves
• 2.4 GHz Cordless phones
In general, wireless devices can communicate through walls. However, if the walls are constructed
with concrete, or have metal, or metal mesh, the effective range will decrease if such materials are
between the devices.

Two Basic Operating Modes

The WG511T Wireless PC Card can operate in the following two basic modes:
•
Infrastructure Mode
communicate with each other by first going through an access point (AP). For example, this
mode is used when computers in a house connect to an Access Point that is attached to a router
which lets multiple computers share a single Cable or DSL broadband Internet connection.
• : An 802.11 networking framework in which devices or computers
Ad-Hoc Mode
communicate directly with each other, without the use of an AP. For example, Ad-Hoc Mode
is used when two Windows computers are configured with file and print sharing enabled and
you want to exchange files directly between them.
Both of these configuration options are available with the WG511T Wireless PC Card.
Infrastructure configuration procedures for basic network connectivity are covered below.
Advanced infrastructure configuration procedures and ad-hoc configuration are covered in
Chapter 4, "Configuration"
3-2
: An 802.11 networking framework in which devices and computers
of this manual.
Basic Setup