NETGEAR RangeMax WPN511 User Manual page 31

5. Verify wireless connectivity between your peer devices.
Verify connectivity by using the Ping program:
a. On the Windows taskbar click the Start button, and then click Run.
Figure 2-6
b. Assuming the target PC is configured with 192.168.0.1 as its IP address, type
ping -t 192.168.0.1
c. This will cause a continuous ping to be sent to the device with the 192.168.0.1 static IP
address. The ping response should change to "reply."
Figure 2-7
At this point the connection is established.
Note: If you cannot connect, see
in Chapter
Windows Client and File and Print Sharing software might not be installed and
configured properly on your computers. See the link to
and TCP/IP Addressing" on page
NETGEAR RangeMax Wireless PC Card WPN511 User Manual
and then click OK.
"Connecting to Wireless Networks and the Internet"
1. Also, for problems with accessing network resources, the
v3.0, January 2007
"Internet Networking
B-1.
2-9