NETGEAR ProSafe ME103 Reference Manual page 42

Reference Manual for the ME103 802.11b ProSafe Wireless Access Point
Table 4-1. General Information Fields
Field
Access Point Information
Access Point Name
MAC Address
Country Domain
Firmware Version
Current IP Settings
IP Address
Subnet Mask
Gateway
IP Address Source
Wireless Settings
Wireless Network Name
(SSID)
Channel
Operating Mode
Security Settings
Authentication
Encryption
802.1x
4-2
Description
The default name may be changed if desired.
Note: In 802.1x mode, this name is used as the client Login name for the
RADIUS server.
Displays the Media Access Control address (MAC address) of the wireless
access point's Ethernet port.
Displays the domain or region for which the wireless access point is
licensed for use. It may not be legal to operate this wireless access point in
a region other than one of those identified in this field.
The version of the firmware currently installed.
These parameters apply to the Local ME103 firewall.
The IP address of the wireless access point.
The subnet mask for the wireless access point.
The default gateway for the wireless access point communication.
Automatic (DHCP client) indicates that the current IP address was
obtained from a DHCP server on your network.
These parameters apply to the target remote ME103 firewall, VPN
gateway, or VPN client.
Displays the wireless network name (SSID) being used by the wireless port
of the wireless access point. The default is NETGEAR.
Identifies the channel the wireless port is using. 11 is the default channel
setting. See "Wireless Channels" on page B-7
each channel.
Identifies the operating mode of the ME103.
WEP or 802.1x authentication setting.
The current WEP or 802.1x encryption setting.
The current 802.1x setting.
August 2003
for the frequencies used on
Maintenance