Table of Contents
Advertisement
Product composition
Check that the package contains the following parts. The number enclosed in < > is the quantity.
Attachment plate <1>
Projector mount bracket <1>
Adapter cover <1>
String <1>
Power cord
(K2CM3YY00038) <1>
Screw with captive washer (M4 x 8) <8>
(ET-JPC200BK: XYN4+F8FJK)
(ET-JPC200WK: 4112055002)
Attention
z After removing the product from the package, dispose of the power cord cap and packing material appropriately.
z The supplied power cord should not be used with projectors other than specified.
z If any part is missing, please contact the dealer.
z Store small parts appropriately in a place out of the reach of infants and small children.
Note
z The part numbers of the parts are subject to change without notice.
z Please note that an assembly test has been performed using all parts so this product may have screw
tightening marks around the parts where the attachment plate and projector mount bracket fit together.
z The product composition, projector, combination of the product and projector, etc. shown in the illustrations may
differ from the actual equipment.
6 - ENGLISH
Falling prevention wire
The attachment plate is mounted to the wall or ceiling to
support the entire product.
The falling prevention wire is secured with tape at the
inner side of the attachment plate.
The projector mount bracket is mounted to the projector
and then attached to the attachment plate.
The adapter cover hides the <AC IN> socket part of the
projector.
This is to prevent the adapter cover from dropping.
Connect to the <AC IN> socket of the optional projector.
These are used to mounting or assembling the product.
Advertisement
Table of Contents
