Table of Contents
Advertisement
Installation (continued)
Connecting the power cord to the projector
This section describes connecting the supplied power cord to the projector.
To prevent the disconnection of the power cord, firmly insert the connector all the way into the <AC IN>
socket of the projector and then secure it in place.
For details on the handling of the power cord, refer to "Read this first!" ( page 3).
<AC IN> socket
Connector
Guide
Connector secure
ⅱ
lock
ⅰ
Tab
Adapter cover
Connector secure
lock
Ribs
Connector
Power supply
unit
Guide
String
1) Check the shapes of the <AC IN> socket of the
projector and the connector of the power cord
and then orient the connector correctly and
insert it firmly.
2) Attach the connector secure lock.
z Attach the connector secure lock by sliding it
along the guides on both sides of the <AC IN>
socket of the power supply unit.
When attaching it, make sure that the connector
of the power cord fits further inside (power
supply unit side) than the ribs on the connector
secure lock.
3) Hook the string of the adapter cover to the
connector secure lock.
z Hook the string that was attached to the adapter
cover beforehand to the connector secure lock
as shown in the figure on the left.
ENGLISH - 23
Advertisement
Table of Contents
