Electrolux ERD052UBGW Instruction Manual page 19

35 electrolux installation
Do not install the refrigerator
outdoors.
Leveling the refrigerator
Install the refrigerator on a
completely level and solid surface.
The door must be closed when
leveling the refrigerator
Use a level with glass-enclosed
bubble to verify whether the
refrigerator is properly leveled, with
the four feet firmly on the floor.
If the refrigerator needs to be
adjusted, carefully lean it and turn
the front adjustable leveling feet until
it is firmly installed.
Proper leveling prevents movement,
vibration and other problems.
Do not substitute the original
refrigerator feet.
Wait at least 2 hours before plugging
the refrigerator in this will prevent
operating problems.
To Level Your Refrigerator:
After discarding crating screws and
wood base, use a carpenter's level to
level the refrigerator from front-to-
back. Adjust the plastic leveling feet
in front, ½ bubble higher, so that the
door closes easily when left halfway
open.
Electrical installation
Before turning on the refrigerator,
check to see if the voltage of the
outlet to be used is the same as that
indicated on the tag located close to
the plug (along the power cord) or on
the refrigerator's identification label.
Check to see that the refrigerator's
plug is not connected on top of the
power cord.
Connect the refrigerator to its own
outlet. Do not use an extension
cord or adaptor plug.
For your safety, ask an electrician to
verify the condition of the electric
wiring in the area where the
refrigerator will be installed.
The wires leading to the outlet into
which the refrigerator will be
plugged should be made of copper
and be at least 2.5 mm2 wide. For
greater safety, consult the legislation
on electrical installations in your
country.
Note: Turning the temperature
control to OFF turns off the
compressor, but does not
disconnect the power to the light
bulb or other electrical components.
Grounding
The power cord has a three-pronged
grounded plug for your personal
safety. It must be connected to a
grounding type wall receptacle, in
accordance with the legislation
governing electric installations in
your country, as well as any local
regulations. Do not remove the
grounding prong, do not use a two
pronged adaptor, and never make a
connection to the schematic. Use
the cord supplied with the
equipment (do not change it). If the
cord is damaged, it must be
immediately replaced by specialized
installation electrolux 36
Attention
For your safety, installation must be
grounded. If it is not grounded, it
must be adapted for this by
specialized personnel.