Table of Contents
Advertisement
Product Illustration
Start Here
The instructions provided in this guide are for installing and using the Model FE116 hub.
Pwr LED
FE116
100BASE-FAST ETHERNET HUB
Pwr
Col
1
2
3
Col LED
LEDs
There are two LEDs on the front panel of the hub and two on each vista 100BASE-T network port
(RJ-45 connector) that allow you to monitor the status of the hub and the network. The table
describes the activity of the LEDs.
Label
Pwr (power)
Col (collision)
Link/Rx (Located on the
top left corner of each
vista network port)
Part (partition) (Located
on the top right corner of
each vista network port)
Vista 100BASE-T Network Ports with Built-in LEDs
The front panel of the Model FE116 hub has sixteen vista 100BASE-T ports. Two LEDs—the
Link/Rx LED and the Part (partition) LED—are built into each 100BASE-T port.
Normal/Uplink Push Button
The Normal/Uplink push button on the Model FE116 hub allows you to select Normal (MDI-X)
or Uplink (MDI) wiring for port 16, eliminating the need to use a crossover cable. Ports 1 to 15 on
the hub are permanently configured for Normal wiring.
Model FE116 Fast Ethernet Hub Installation Giude
Front Panel of the Model FE116 Hub
vista 100BASE-T
network ports
F
100 Mbps
AST
4
1
2
3
4
9
10
11
12
Color
Activity Description
Green
On
Power is supplied to the hub.
Amber
Blinking Data collision is occurring on the network. Note
that occasional collisions are normal.
Green
On
The link between this port and the connected
device is good.
Blinking
There is incoming data on the port.
Amber
On
The port is partitioned because of excessive
collisions.
vista 100BASE-T
network port
Link/Rx
Part
LED
LED
8494FA
Link/Rx
Part
Normal/Uplink
13
14
15
16
Normal/Uplink
push button
8493FA
Advertisement
Table of Contents
