Table of Contents
Advertisement
6.9 OPTIONAL ENHANCED RAM+ SECOND STATION MIC
AND/OR VH-310 HANDSET INSTALLATION
The GX1500E is capable of using a Enhanced RAM+ mic or VH-310 Handset
to remotely control the Radio, DSC, and Distress functions. In addition the
GX1500E can operate as a full function intercom system.
1. Connect the Routing Cable to the Remote Mic eight pin connector on the
rear panel, then tighten the Cable Nut (See Figure 3).
2. Referring to Figure 4, make a 30 mm hole in the wall, then insert the Rout-
ing Cable into this hole. Connect the Gasket and Mount Base to the Rout-
ing Cable Connector using the Nut.
3. Drill the four Screw holes (approx. 2 mm) on the wall, then install the Mounting
Base to the wall using four screws.
4. Put the Rubber Cap on to the Nut. The installation is now complete.
5. Wires for a external speaker are provided on the Routing Cable. Connect
any 8 Ohm external speaker. When connected the RAM+ (or VH-310 Hand-
set) controls the volume level of this speaker.
Page 14
Figure 3
Wall
Black and White wires are for
connection of a MLS-300 or
MLS-310 External Speaker
Gasket
Routing Cable
Mounting Bracket
Figure 4
Cap
Nut
GX1500E
Advertisement
Table of Contents
