Friedrich KCS08A10A Service Manual page 40

Premium Carbon Filter Removal / Installation Instructions
1.
Remove the filter per Standard Filter Removal Installation Refer to Figure 402 and 403.
2.
Hold the filter at the top and slide the grip out as shown on Figure 405.
3.
If you already have a carbon filter installed remove the dirty filter by laying the filter down and swinging open the front
frame as shown in Figure 406.
NOTE: Make sure the frame with the mesh is facing toward you.
4.
Place the new carbon filter on the top of the back filter frame. The carbon filter has been cut to the correct dimension
and should fit within the frame as shown in Figure 406.
NOTE: The carbon filter is not a reusable filter, and needs to be replaced every three months for optimum efficiency.
5. Slide the filter handle back on to hold the frames together and slide the assembly into the unit as per the instructions
on the door.
NOTE: The filter handle slides into the frame in only one direction. If the tab in the frame stops the handle from sliding in, slide
the handle from the other direction. DO NOT FORCE THE HANDLE INTO THE FRAME.
Figure 405
40
ROUTINE MAINTENANCE
FRONT FRAME WITH
MESH FILTER
ALIGN HOLES WITH
PROTRUSION
Figure 406