Haier HW90-BP14959 User Manual page 17

5.10 Start wash programme
Press "Start/Pause" button (Fig.5-8) to start. Applia-
nce operates according to present settings. Changes
are only possible by cancelling the programme.
5.11 Interrupt / cancel wash programme
To interrupt a running programme press gently "Start/Pause". The LED in the button is
flashing. Press it again to resume operation.
To cancel a running programme and all its individual settings:
1. Press "Start/Pause" button to interrupt the running programme.
2. Turn the knob to select a new programme and start it.
5.12 After washing
Note: Door lock
For safety reasons the door is locked partially during the washing cycle. It is only pos-
sible to open the door at the end of the programme or after the programme was can-
celled correctly (see description above).
In case of high water level, high water temperature and during spinning it is not pos-
sible to open the door;
1. A t programme cycle end
2. The appliance switches off automatically.
3. R emove laundry as soon as possible to go easy on it and to prevent more wrinkl-
ing.
4. Turn off the water supply.
5. Unplug the power cord.
6 O pen the door to prevent formation of moisture and odours. Let it open while not used
minutes before starting the programme or at the end of programme.The display
switches off.
Note: Standby mode / energy-saving mode
The switched on appliance will go into standby mode if it will not be activated within 2
minutes before starting the programme or at the end of programme. The display s-
witches off. The saves energy.
5.13 Act ivate or deactivate the buzzer
The acoustic signal can be deselected if necessary:
1. Switch on the appliance.
2. Select the Drum Clean programme.
Press the "Extra rinse" button "Temp." button and "Steam" button at the same time
for about 3 seconds. "
For activating the buzzer press these three buttons at the same time again, then "
" will be displayed.
is displayed.
is displayed.
" will be displayed and the buzzer will be deactivated.
5-Daily use
se
5-8
.
16