Table of Contents
Advertisement
3.3.7.2 Capstan Using 3/32" Cable w/Retainer Clips
1) Insert swaged ball end of the first cable (233-20003-00) into the top end slot of the unit capstan. See
Figure 3-10.
Figure 3-10. Inserting 3/32 cable in the unit capstan.
2) Wrap the cable around the unit capstan approximately three and one half turns, leaving just enough
cable to reach the bottom end slot of the test fixture capstan. See Figure 3-11. Turning the test fixture
solenoid switch on will hold the unit capstan in place and make winding easier.
Figure 3-11. Cable around unit capstan, showing end of cable near test fixture capstan
GSA 8X/GSM 85(A) Installation Manual
190-00303-72
bottom slot
Page 3-9
Revision R
Advertisement
Table of Contents
