Electrolux HOOT11E Installation Manual page 20

6. Assemble the Touch Screen Panel on the left
side on the oven, as indicated in the "Oven
Service Manual".
7. Follow the instructions in point G.2 below to set
the ovens correctly.
MASTER OVEN
F.7.4 Hood-ovens interface cable for Stacked
mode
To connect the hood 922722 and 922721 with
stacked ovens (two ovens working together),
proceed as follow:
1. connect the upper oven (named MASTER)
following previous instruction ( F.7.3 Hood-
oven interface cable );
2. Remove the left side panel of under oven
(named SLAVE), as indicated in the its "Oven
Installation Manual";
3. Remove the pre-cut sheet on the oven base to
obtain a 21mm hole;
4. Insert the male thread curve supplied, relevant
to the interface cable, and secure it with the
nut supplied;
5. Remove the Touch Screen Panel from the
oven, as indicated in the "Oven Installation
Manual";
6. Insert the special interface cable (L= 8,00 mt)
connectors on the relevant positions indicated
X50 and X52;
7. Assemble the Touch Screen Panel on the left
side on the oven, as indicated in the "Oven
Installation Manual".
8. Open the upper Hood Technical Compartment
and connect the interface cable on main-board
in CN1 and CN2 position;
9. Follow the instructions in point G.2 below to set
the ovens correctly.
SLAVE OVEN
20