Electrolux COOKING Service Manual
Electrolux COOKING Service Manual

Electrolux COOKING Service Manual

Built-in appliances and floor-mounted stoves with avantgarde input electronics
Hide thumbs Also See for COOKING:
Table of Contents

Advertisement

© Electrolux Distriparts
Muggenhofer Straße 135
D-90429 Nürnberg
Germany
Fax +49 (0)911 323 1022
DGS-TDS-N
Edition:
05.09
Publ.-Nr.:
599 521 367
685
EN
SERVICE MANUAL
COOKING
Built-in appliances
and floor-mounted
stoves
with „Avantgarde"
input electronics

Advertisement

Table of Contents
loading

Summary of Contents for Electrolux COOKING

  • Page 1 SERVICE MANUAL COOKING Built-in appliances and floor-mounted stoves with „Avantgarde“ input electronics © Electrolux Distriparts Publ.-Nr.: Muggenhofer Straße 135 599 521 367 D-90429 Nürnberg Germany Fax +49 (0)911 323 1022 DGS-TDS-N Edition: 05.09...
  • Page 2: Table Of Contents

    High-speed heating - Explanation ..................9 Safety function safety cutoff of oven .................. 10 Safety function safety cutoff of cooking zones ..............10 Functional parts - Component data, installation situation, dismantling ......11 Functional parts - Oven control ..................11 4.1.1...
  • Page 3: Esd=Electrostatic Discharge

    Endangered are all assembly groups which are provided with control entries, wire paths lying open and free-accessible processors. DGS-TDS-N 05.09 A. B. © Electrolux - 3 - 599 521 367...
  • Page 4: Software Specifications, Functions

    Minus/Plus (e.g. for clock, meat thermometer, etc.) Key 10 Meat thermometer selection switch Key 11 and 12 Minus/Plus (e.g. for clock, meat thermometer, etc.) Key 13 Double-oven selection switch Key 14 Clock selection switch DGS-TDS-N 05.09 A. B. © Electrolux - 4 - 599 521 367...
  • Page 5: Main Features Of Operation

    Caution: the child-proof lock remains activated even when there is a voltage drop. Additional important information on this subject is included in Chapter 3.6 "Special instructions on hob/oven communication in floor-mounted appliances". DGS-TDS-N 05.09 A. B. © Electrolux - 5 - 599 521 367...
  • Page 6: Functions Of Appliance

    Pos.3 3030 13,2 Pos.4 3030 13,2 Pos.5 (top-/bottom el.) 2090 Pos.6 3030 13,2 Pos.7 2130 Pos.8 1090 Pos.9 Pos.10 (keeping warm) 2090 Pos.11 120/80 3030 13,2 Manual booster DGS-TDS-N 05.09 A. B. © Electrolux - 6 - 599 521 367...
  • Page 7 Pos. 3 3030 13,2 Pos. 4 3030 13,2 Pos. 5 2990 13,0 Pos. 6 (keeping warm) 2090 Pos. 7 1105 Pos. 8 Pos. 9 120/80 2030 Booster "AUTO" DGS-TDS-N 05.09 A. B. © Electrolux - 7 - 599 521 367...
  • Page 8: Pyrolitical Cleaning - Explanation

    Heating period 150min > Heating period 120min > Heating period 90min Note: In appliances which are equipped with two pyrolysis durations, P2 corresponds to the pyrolysis duration P3. DGS-TDS-N 05.09 A. B. © Electrolux - 8 - 599 521 367...
  • Page 9: High-Speed Heating - Explanation

    Note: Quick-Heating function - manual operation Quick-Heating function „AUTO“ - Automatically active, not switchable The type of Quick-Heating function available is in Chapter 3.1. DGS-TDS-N 05.09 A. B. © Electrolux - 9 - 599 521 367...
  • Page 10: Safety Function Safety Cutoff Of Oven

    Pyrolyse. Safety function safety cutoff of cooking zones If the cooking zones are not switched off after a certain period of time, or the temperature not changed, they switch off automatically. The temporal cutoff depends on the set cooking level: DGS-TDS-N 05.09 A.
  • Page 11: Functional Parts - Component Data, Installation Situation, Dismantling

    After pressing in the notch (see figure) and drawing it afterwards to the right side of the appliance, the user interface can be removed backward, in direction of the appliance's interior. With upright stoves, there may be different scenarios of fitting positions. DGS-TDS-N 05.09 A. B. © Electrolux - 11 - 599 521 367...
  • Page 12 It is provided with nine sensors which transmit the received impulses to the user interface. This happens via a data link in form of a foil conductor. DGS-TDS-N 05.09 A. B. © Electrolux - 12 -...
  • Page 13: Power Electronic Ovc2000

    These two components, power electronics and plastic box, are also a replacement part unit (see Ill.) Please refer to Chapter 7 for connection designations and possible measuring points. DGS-TDS-N 05.09 A. B. © Electrolux - 13 - 599 521 367...
  • Page 14: Temperatursensor Pt500

    ON/OFF the cooling fan. Fig. Temperature sensor Fig. Electrical resistance of sensor depending on the ambient temperature DGS-TDS-N 05.09 A. B. © Electrolux - 14 - 599 521 367...
  • Page 15: Door Locking Systems

    The Klixon is arranged at the transverse beam beside the hot air motor (Fig. 2). Fig. 1, Door lock Fig. 2, Arrangement of Klixon Fig. Switching of door lock DGS-TDS-N 05.09 A. B. © Electrolux - 15 - 599 521 367...
  • Page 16 For unlocking, a voltage of 230 V must be applied to contacts 2 and 3. The bar “A” moves backwards and releases the lock lever. The door can be opened provided that the contact f11 (Klixon) is closed. DGS-TDS-N 05.09 A. B. © Electrolux - 16 - 599 521 367...
  • Page 17: Door Locking System, Motorics With Door-Switch Light

    When opening the door of the oven, the lighting of the oven is activated over this component after the device has been switched on. The mounting position is at the top and right-hand corner of the front frame of the oven DGS-TDS-N 05.09 A. B. © Electrolux - 17 - 599 521 367...
  • Page 18: Light Bar In The Control Panel

    The activation of the light bar occurs through a activation electronics that is hafted on the lower surface of the front cover. It provides the light bar with a voltage of 7V/18mA. DGS-TDS-N 05.09 A. B. © Electrolux - 18 -...
  • Page 19: Functional Parts - Cooking Setting Control

    Functional parts - Cooking setting control 4.2.1 Power controller Fig. Power controller Fig. Switch in „OFF“ position Input voltage 230 V Fig. Performance characteristic K1 – Knob position % ED – Switching on period in percent 100 % corresponds to a switching on period of 41 seconds The hot plates are controlled via the bimetallic contact P 1-2.
  • Page 20: Input Electronic Hoc2000 And Input Module

    Fig.: input electronic HOC2000 and Input module in installed condition Input electronic HOC2000 LED display description of connection 3d view Attention: The HOC2000 input electronics also consist of ESD-sensitive components. DGS-TDS-N 05.09 A. B. © Electrolux - 20 - 599 521 367...
  • Page 21 1a make contact 1 The appropriate cooking zone relay which is located on the HOC2000 power board is provided with voltage via the main switch (make contact) 1/1a of the cooking zone switch (input module). The make contact is already closed from the first switching step. This corresponds to a rotation of 30°...
  • Page 22: Cooking Zone Power Board Hoc2000

    It receives the electrical control signals transmitted by the input boards and supplies the relevant heating element (cooking zones) with power depending on the impulse/s. The control relays select the various cooking zones, its number may change according to the type of appliance.
  • Page 23 Note: A built-in cooker must be removed completely from the built-in cavity for disassembling the power board. DGS-TDS-N 05.09 A. B. © Electrolux - 23 - 599 521 367...
  • Page 24: Technical Equipment

    120°C-130°C. The post-operative ventilation is controlled via the electronics. Note: for wiring diagram see chapter 7 Deviations possible with floor-mounted stoves Measure against wrong electrical connection Not provided. DGS-TDS-N 05.09 A. B. © Electrolux - 24 - 599 521 367...
  • Page 25: Oven Rack Protective Circuit

    äußeren Seite der Komponentenplatte. Only with attached oven racks, not with slide-in grids, the microswitch interrupts a switch contact which prevents an activating of the pyrolytic function. Note: for wiring diagram see chapter 7 DGS-TDS-N 05.09 A. B. © Electrolux - 25 - 599 521 367...
  • Page 26: Fault Diagnosis/ What To Do If

    Internal electronics error Replace power electronics software error Replace input electronics Internal electronics error Replace input electronics Combined alarm Pyrolytic cleaning/cooking zone Replace input electronics DGS-TDS-N 05.09 A. B. © Electrolux - 26 - 599 521 367...
  • Page 27: Measuring The Temperature Sensor

    Make sure to measure the insulation resistance between the metallic housing and each connection terminal. The resistance should be higher than 2 MOhms. Abb. Measuring the temperature sensor DGS-TDS-N 05.09 A. B. © Electrolux - 27 - 599 521 367...
  • Page 28: Demo Mode Input Electronic Avantgarde

    Demo Mode input electronic Avantgarde 6.3.1 Activating/deactivating Version a OBER-/UNTERHITZE OBER-/UNTERHITZE Sprache einstellen Language Menu Fig. 1 Fig. 2 Fig. 3 Fig. 4 DGS-TDS-N 05.09 A. B. © Electrolux - 28 - 599 521 367...
  • Page 29: Activating / Deactivating Version B

    Switching the appliance on with the main switch Display: active Demo Mode ---> "Time" (fig. 5), even if the appliance is switched off. deactivated Demo Mode ---> none (fig. 6) Fig. 5 Fig. 6 DGS-TDS-N 05.09 A. B. © Electrolux - 29 - 599 521 367...
  • Page 30: Factory Test / Türverriegelungstest

    For activation actuate keys 6 and 7 simultaneously until a signal sounds. The display indicates „TEST“. The factory test ends automatically after 5 minutes. By actuating key 7 it can be stopped early. DGS-TDS-N 05.09 A. B. © Electrolux - 30 - 599 521 367...
  • Page 31: Wiring Diagram / Measuring Points

    Wiring diagram / measuring points Connection Point Overview DGS-TDS-N 05.09 A. B. © Electrolux - 31 - 599 521 367...
  • Page 32: Example Circuit Diagram Ovc 1000

    Example circuit diagram OVC 1000 DGS-TDS-N 05.09 A. B. © Electrolux - 32 - 599 521 367...
  • Page 33: Example Circuit Diagram Ovc 2000

    Example circuit diagram OVC 2000 DGS-TDS-N 05.09 A. B. © Electrolux - 33 - 599 521 367...
  • Page 34: Example Circuit Diagram Soec

    Example circuit diagram SOEC DGS-TDS-N 05.09 A. B. © Electrolux - 34 - 599 521 367...
  • Page 35: Example Circuit Diagram Prisma

    Example circuit diagram Prisma DGS-TDS-N 05.09 A. B. © Electrolux - 35 - 599 521 367...
  • Page 36: Example Circuit Diagram Hoc 2000

    Example circuit diagram HOC 2000 DGS-TDS-N 05.09 A. B. © Electrolux - 36 - 599 521 367...
  • Page 37: Operative Equipment Overview

    Operative Equipment Overview DGS-TDS-N 05.09 A. B. © Electrolux - 37 - 599 521 367...
  • Page 38: Changes

    Changes Pages Chapter 6.1 changed DGS-TDS-N 05.09 A. B. © Electrolux - 38 - 599 521 367...

This manual is also suitable for:

Ovc 2000Ovc 1000Hoc 2000

Table of Contents